EPSON Stylus Pro 7600/9600

Revision A

4.3.8 HEAD_SLIDE Sensor ASSY

CAUTION When unlocking the carriage, do not move the carriage by about 2 cm or more with the cutter pushed into the innermost position;

otherwise, the cutter edge would be damaged.

1.Remove the R Side Cover. (p.160)

2.Remove the Access Cover. (See Removing the Access Cover on page 167)

3.While pushing the cutter area gently, shift the carriage to the left about 2 cm to unlock the carriage and then move the carriage to the left from the capping position.

(See Figure 4-24)

4.Disconnect the connector (CN29: red 4-pin) of the HEAD_SLIDE Sensor ASSY from the Main Board and take it out through the hole in the R Side Frame.

5.Remove the one (CP(W): M3⋅6) screw securing the HEAD_SLIDE Sensor ASSY and remove the HEAD_SLIDE Sensor ASSY.

(See Figure 4-44)

6.Release the harness for the HEAD_SLIDE Sensor ASSY from the five cable clamps on the Maintenance ASSY and CR Rail ASSY.

(See Figure 4-45)

Screws (CP(W): M36)

HEAD_SLIDE Sensor ASSY

Figure 4-44. Removing the HEAD_SLIDE Sensor ASSY

Clamp

Clamp

Clamp

Clamp

Figure 4-45. Releasing the HEAD_SLIDE Sensor ASSY Harness

Disassembly & Assembly

Disassembly and Assembly of Carriage (CR) Mechanism

182

Page 182
Image 182
Epson 9600, 7600 service manual Removing the Headslide Sensor Assy