Epson 7600, 9600 service manual Paper set lever is released, Paper Jam, Front Cover Open

EPSON Stylus Pro 7600/9600 Revision A

3.2.2.4 Paper set lever is released

	Table 3-8.
Item	Description
LCD PANEL	LOWER PAPER SET LVR
MESSAGE
LED STATUS	“PAPER OUT” LED lights up.
Explanation	Paper set lever is released during paper set operation.
	The error display will be cleared after finishing paper set and
Recovery	pushing down the lever, and message “PRESS PAUSE BUTTON”
	will appear.
	Refer to user's manuals for paper setting procedure.

3.2.2.5 Paper Jam

	Table 3-9.
Item	Description
LCD PANEL	PAPER JAM
MESSAGE
LED STATUS	“PAPER OUT” LED is blinking.
	While printing, feeding or cutting, a jammed paper prevents the
Explanation	CR motion. Paper jam is detected if one of rear and front paper
	sensor detect paper existing and over drive current or mis-
	synchronization of CR motor is detected.
	† After removing the jammed paper, “TURN PWR OFF AND
Recovery	ON” is displayed and then reboot by turning off and on
	according to the message.
	† Check the paper path for foreign matters or any deformed parts
	which can cause a paper jam.

Note : Errors in the drive system can occur in case of out-of-step, overcurrent or any other significant deviation from command values to the servo motor.

3.2.2.6 Front Cover Open

	Table 3-10.
Item	Description
LCD PANEL	FRONT COVER OPEN
MESSAGE
LED STATUS	None
	Front cover is opened. Under this error, all of CR motion and ink
Explanation	sequences are halted. Therefore it may give damages to printing
	head if this situation continues very long time.
	† Close the front cover. If it is happened with print ready status
	during printing, it recovers to print ready status automatically. If
	it is happened during pause, it recovers to pause status
	automatically. If the cover is opened during printing, the
	suspended printing pass is never resumed. Therefore there may
	appear a stripe on the printout. It is better to make the printer
	PAUSE by pressing the Pause button prior to open the cover
Recovery	while printing, however there may appear a uneven-coloring on
	some media because of the difference of printing time.
	† If the error is not cleared even after cover closing,
	Execute Checking Cover Sensor Operation in the self-
	diagnostics menu and if any problem is found, take corrective
	action.
	1. Check that the cover is closed properly.
	2. Replace the sensor.

Troubleshooting Error Display 127