Epson 7600, 9600 Paper check error/Paper eject error sheet, Paper is too thick for cleaning

EPSON Stylus Pro 7600/9600 Revision A

3.2.2.10 Paper check error/Paper eject error (sheet)

	Table 3-14.
Item	Description
LCD PANEL	RELOAD PAPER
MESSAGE
LED STATUS	“PAPER OUT” LED is blinking.
	This error occur in following cases
	1. The top length of ejected paper is too long to be back-fed
	when paper is set.
	2. Paper's horizontal position exceeds the normally printable area
	when paper is set.
Explanation	3. Paper's horizontal position exceeds the normal cutting
	permission area just after printing.
	4. Length of sheet exceeds the ejectable length and cannot be
	ejected completely.
	5. After recovery of cutter error.
	See “3.2.2.8 Paper cutting error (p.128)”.
	In case of 1,2,3, user should set the paper again according the
	User's guide exactly. If the top of the paper has indentation, it
	should be trimmed. In case of 4,5, the ejected portion of paper top
Recovery	should be removed and then user set paper again. User can cut the
	portion using auto cutter after paper set lever is lifted up (in this
	time, it shifts to “RELOAD PAPER”), horizontal position is reset
	straight, paper set lever is pushed down, roll paper auto cut is
	selected, and “Paper Cut/Eject” button is pushed if the paper
	cutting is possible.

3.2.2.11 Paper is too thick for cleaning
	Table 3-15.
Item	Description
LCD PANEL	REMOVE PAPER
MESSAGE
LED STATUS	PAPER OUT LED is blinking.
Explanation	This error occurs when cleaning is executed although a paper
	thickness of with1.2mm is set.
Recovery	Cleaning is executed automatically when paper is removed and the
	paper set lever is set.

3.2.2.12 Not enough ink for cleaning

	Table 3-16.
Item	Description
LCD PANEL	NOT ENOUGH INK
MESSAGE
LED STATUS	INK OUT LED goes on
	This error occurs when cleaning is executed although the amount
Explanation	of ink necessary for cleaning is not left in each ink cartridge. The
	amount of ink necessary differs with each cleaning. *Timer CL
	and others are excluded.
	This error clears automatically after about 5 seconds. Error
	message appears again during cleaning, unless all the installed
Recovery	cartridges are replaced with ones with enough ink for cleaning.
	The message “NOT ENOUGH INK” is displayed on the panel for
	5 seconds. The corresponding “INK OUT” LED goes on for 5
	seconds to alert the user to the error. The error is cleared by
	pressing Pause button during the 5 second period.

Troubleshooting Error Display 129