Epson 9600, 7600 service manual Paper End/End of roll, Wrong paper source is selected on panel

EPSON Stylus Pro 7600/9600 Revision A

3.2.2 Errors

3.2.2.1 Paper End/End of roll

		Table 3-4.
Item		Description
LCD PANEL	PAPER OUT
MESSAGE
LED STATUS	“PAPER OUT” LED lights up.
	The error occurs in following cases.
	† [A]: Paper is not set.
Explanation	† [B]: The printer detects end of the roll. In this time the paper
		feed roller holds and keeps the end of the roll.
	† [C]: The printer completed a printing on a sheet or detects end
		of the sheet. In this time the paper feed roller holds and keeps
		the end of the sheet.
	† Set paper.
		In the case of [B] and [C] above, remove the paper and set new
		paper.
		After setting new paper, the error will be cleared. If the printing
		data remains in the printer, the printing job will continue on the
		newly set paper. When printing job continue, the printer ejects
		buffer content, cuts or ejects the paper, and starts printing after
		developing new data. Remained data is printed and ejected with
		paper length designated with the command.
	† If the error is not cleared even after paper setting,
Recovery		Possible causes are problems with the following sensors. Take
		corrective action as instructed below.
	•	P_REAR sensor
	•	P_EDGE sensor
	1.	Check for paper dust or foreign matters on the sensor and clean
		it.
	2.	Check the operation of each sensor and make AD adjustment in
		the self-diagnostics menu.
		(Rear AD Adjustment (p.231) / Edge AD Adjustment (p.232))
		Note: Change the location of the printer if there may be an
		effect of any strong external light, such as the sunlight.

3.2.2.2 Wrong paper source is selected on panel

	Table 3-5.
Item	Description
LCD PANEL	LOAD xxx PAPER
MESSAGE
	“PAPER OUT” LED lights up.
LED STATUS	The LED blinks corresponding to paper path set with PP
	command of remote command. (See Table 3-6)
Explanation	Different paper source is selected on panel from the paper source
	that is selected by PP command.
	Replace the paper into one that is selected by command, or the
Recovery	error will be also cleared by toggle the paper source setting on
	panel, if only the panel setting is wrong. After it is cleared, it is
	ready to print.

Table 3-6. LED Indications for Wrong Setting (Roll Paper/Sheet)

PP Command	Roll paper auto cut	Roll paper manual cut	Sheet LED
	LED	LED
Roll Paper	Blink	Blink	Off
Sheet	Off	Off	Blink

3.2.2.3 Paper set lever is released during operation

	Table 3-7.
Item	Description
LCD PANEL	SET PAPER LEVER
MESSAGE
LED STATUS	“PAPER OUT” LED lights up.
Explanation	Paper set lever is released during operation
Recovery	It is cleared with pushing down the lever, and the printer continues
	the operation.

Troubleshooting Error Display 126