Epson 7600, 9600 service manual Paper thickness sensor PG setting Saving place Setting, Std

EPSON Stylus Pro 7600/9600 Revision A

Table 1-44.

Paper thickness sensor	Paper thickness	PG setting	Saving place	Notes
	setting
Less than 0.7mm	STD	-	For PG1.2mm	*1
More than 0.7mm		-	PG2.6mm
Less than 0.3mm	0S	-	For film media	*2
			(PG0.7mm)
More than 0.3mm		*6
Less than 0.3mm	3S	-	For glossy media	*3
			(PG0.7mm)
More than 0.3mm		*7
Less than 0.3mm	0.0mm	Narrow	For PG0.7mm
		Standard	For PG0.7mm
		Wide	For PG1.2mm
		Wider	For PG2.2mm
	0.1~0.6mm	Narrow	For PG0.7mm
		Standard	For PG1.2mm
		Wide	For PG2.2mm
		Wider	For PG2.6mm
	0.7~1.6mm	-	For PG2.6mm	*4
More than 0.3mm	0.0~0.6mm	Narrow	For PG1.2mm
Less than 0.7mm
		Standard	For PG1.2mm
		Wide For	PG2.2mm
		Wider	For PG2.6mm
	0.7~1.6mm	-	For PG2.6mm	*4
More than 0.7mm	0S/3S/	-	For PG2.6mm	*5
	0.0~1.6mm

Note 1: Paper thickness is saved to adjust with 0.1mm unit for paper thickness setting command PH.

2:Paper thickness is firstly entered to reduce operation with the closest pattern print of adjustment value saved in the printer.

3:Select "STD" when authentic EPSON dedicated paper is to be used. Then the paper thickness sensors detect the paper thickness and make automatic setting.

(Thin paper = 0.2mm / Thick paper = 1.2mm)

4:When the following paper is to be used, select [0S] or [3S].

[0S] = Films and special thin paper

[3S] = Recommended thick RC paper for borderless printing

5:When any paper other than authentic EPSON dedicated paper is to be used, set paper thickness in increments of 0.1 mm.

Note *1: Adjustment values calculated with PG1.2mm for PG 0.7mm, 2.2mm, 2.6mm are saved except adjustment value saved for PG 1.2mm at that time.

*2: In this case, adjustment value is saved into PG0.7mm area as a special setting for film media (paper thickness 0.15mm). This is used when special setting for film media (00h) is set with PH command.

*3: In this case, adjustment value is saved into PG0.7mm area as a special setting for glossy media (paper thickness 0.3mm). This is used when glossy media is specified with paper adjustment value of paper feed adjustment setting command.

*4: Even when paper thickness sensor detects thin paper (less than 0.7mm), PG is set as 2.6mm if paper thickness setting is more than 0.7mm.

*5: When paper thickness sensor detects thick paper (more than 0.7mm), PG is set as 2.6mm regardless of PG setting and paper thickness setting.

*6: It is saved into saving place for paper thickness 0.0mm.

*7: It is saved into saving place for paper thickness 0.3mm.

Product Description Operating Panel 61