Epson 9600, 7600 service manual Removing the AC Inlet Holder

EPSON Stylus Pro 7600/9600 Revision A

4.7.2 AC Inlet

CAUTION Unplug the AC power cable and wait at least five minutes before removing the Power supply Board to make sure there is no residual

power left in the board's capacitors.

1.Remove the Rear Cover. (p.166)

2.Disconnect CN001 from the Power Supply Board. (See Figure 4-81)

3.Remove the one screw (M4⋅8) and toothed washer (M4) fastening the AC Inlet Ground Cable.

4.Push the hooks (one top and two bottom hooks) and remove the AC Inlet from the holder. (See Figure 4-82)

Install the AC Inlet in such an orientation that the ground cable side is positioned up.

Up: Ground cable

Screw (M4⋅8), toothed washer

CN001 Ground cable

AC Inlet Holder

Figure 4-81. Removing the AC Inlet Holder

AC Inlet Holder

Hook ⋅1

AC Inlet

Hooks ⋅2

Figure 4-82. Removing the AC Inlet

Disassembly & Assembly Disassembly and Assembly of Circuit Boards 206