Epson 9600, 7600 service manual Sensors, Menu Transition of Sensor Test

EPSON Stylus Pro 7600/9600 Revision A

5.2.2.3 Sensors

Sensor status is displayed on the panel.

†The numerals shown at the item “Paper” means that the paper thickness is as follows:

„00 : 0.3 mm or below in paper thickness

„01 : 0.4 mm ~ 0.8 mm in paper thickness

„11 : 0.9 mm or more in paper thickness

„10 : The lever is in the up position.

NOTE: When adjustment is required, see “5.2.3.1 Rear AD Adjustment (p.231)”.

†“INK NOT” indicates the absence of color ink cartridges.

Each symbol displayed signifies that the corresponding color ink cartridge is absent.

†For Edge AD and Rear AD, the value shown around the center represents the ON- OFF difference and the value shown at right represents the ON level.

The standard for accepting each AD value is as follows:

„Rear AD: 40 or more in ON-OFF difference and 95 or less in ON level

„Edge AD: 40 or more in ON-OFF difference and E0 ~ E8 in ON level

NOTE 1: For adjustment procedure, see “5.2.3.2 Edge AD Adjustment (p.232)” and “5.2.3.1 Rear AD Adjustment (p.231)”.

2:With Stylus Pro 7600, the item “TAKE UP” is not displayed.

Sen:
? CR Origin	On
Sen:
? Cover	Close
Sen:
? Paper	00
Sen:
? Lever	Down
Sen:
? HeadSlide	On

Sen:
?INK NOT	KkCMcmY
Sen:
? InkLever		Down
Sen:
? Edge AD		04A 0E2
Sen:			* Not used
? Front AD	041 068
Sen:
? Rear AD	041 068
Sen:
? Head Temp		25°C
Sen:
? Drv. Temp		25°C
Sen:
? TAKE UP		Off
Sen:
? MainteTank		On

Figure 5-6. Menu Transition of Sensor Test

Adjustment Self-diagnostic Function 224