: Ink end error occurs when the defined amount of ink have been consumed after NearEnd is detected. It occurs when NearEnd cartridge is inserted, whether the defined amount of ink have been consumed or not.
: There detected any ink cartridge slot without cartridge.

EPSON Stylus Pro 7600/9600

Revision A

3.2.2.13 Ink-related Errors

„ Ink End (error)

„ No Ink Cartridge

„Wrong/Non-genuine Ink Cartridge (dye / pigment):

 

This error occurs when wrong ink type (dye / pigment)

 

is installed.

 

Table 3-17.

 

 

Item

Description

 

 

LCD PANEL

“INK OUT”, “NO INK CARTRIDGE” or “INVALID

MESSAGE

CARTRIDGE“

 

 

LED STATUS

Corresponding color LED lights up

 

Check the CSIC contact terminal on the I/C Holder and the CSIC

Recovery

terminal on the ink cartridge. (damage or deformation)

If no problem with the CSIC terminals is found, install a new ink

 

 

cartridge.

 

 

3.2.2.14 Defective ink cartridge

 

Table 3-18.

 

 

Item

Description

 

 

LCD PANEL

INK OUT

MESSAGE

 

 

 

LED STATUS

This error occurs when the ink cartridge CSIC has some problems

with the contents and has loose connection. Corresponded “INK

 

OUT” LED goes on.

Explanation

There detected some problems with the contents of the ink

cartridge CSIC. Reading/writing into ink cartridge was failed.

 

 

 

 

In case of loose connection, release the ink lever (at this time the

Recovery

massage “SET INK” is displayed and reload the ink cartridge.

When the error is not recovered, open the ink compartment, and

 

 

then replace cartridge with new full one.

 

 

3.2.2.15 Ink lever released

 

Table 3-19.

 

 

Item

Description

 

 

LCD PANEL

SET INK LEVER

MESSAGE

 

 

 

LED STATUS

None

Explanation

It is happen when ink lever is released.

 

 

Recovery

Set the ink lever.

 

 

Troubleshooting

Error Display

130

Page 130
Image 130
Epson 9600, 7600 service manual Ink-related Errors, Defective ink cartridge, Ink lever released