Lincoln Invertec V160-S Welder Manual - Operation and DIP Switch Functions

B-4	OPERATION	B-4

DIP SWITCH FUNCTIONS

This section has 8 DIP switch functions of the V160-

S.Read and understand the functions before making any changes because abnormal operation can occur with the wrong settings. The machine must be turned OFF when the DIP Switches are changed.

WARNING

ELECTRIC SHOCK CAN KILL:

Be sure that all installation, opera- tion, maintenance and repair proce- dures are performed only by qualified individuals. Lincoln Electric is not responsible for damages caused by

improper installation, improper care or abnormal operation.

Before opening the machine to make changes to the DIP Switches it must first be turned OFF and disconnected from the input source. Do not open the machine or change the DIP Switches with power applied to the machine. Only Lincoln trained service technicians are authorized to per- form these modifications.

------------------------------------------------------------------------

The DIP switches are numbered from 1 to 8 shown in Figure B.3. Switch 1 is on the bottom and switch 8 is on the top. When a switch is pushed to the right (or to the back of the machine) it is ON; when it is pushed to the left (or to the front of the machine) it is OFF.

The standard production settings for the V160-S are shown with in bold letters ON Table B.1. If a switch setting has bold letters ON, do not make any changes; abnormal operation could occur.

TABLE B.1

	DIP	V160-S	V160-S
	Switch	CE	USA

1		ON	ON
	2	OFF	OFF
	3	OFF	ON
	4	ON	OFF
	5	OFF	OFF
	6	OFF	ON
	7	OFF	OFF
	8	OFF	OFF

DIP Switch 1: Machine Type

This controls the output of the V160-S and some welding waveform functions. It configures the V160-S to automatically turn ON depending on the position of the Welding Mode switch. Refer to DIP Switch 6 for more information.

DIP Switch 2 thru 5 non-functional for the V160-S.

FIGURE B.3

Front of machine

DIP

Switch 8

DIP

Switch 1

V160-S

OPERATION