OPERATION
WARNING!
To reduce the risk of injury, wear safety goggles or glasses with side shields. Unplug the tool before changing accesso- ries or making adjustments.
Starting and Stopping the Motor
Plug in the tool. To start the tool, squeeze the paddle trigger. Release the paddle trigger to stop tool.
1.To start the tool, squeeze the paddle trigger.
2.To stop the tool, release the paddle trigger.
Sanding Disc and Grinding Wheel Selection
Use sanding discs and grinding wheels that are:
•correct size as written on tool's nameplate.
•correct wheel type and grit for the job.
•rated at or above the RPM listed in the "WARNING" section on the tool's nameplate.
Use backing pads, adapters, and other accessories that are:
•correct size for tool and for sanding disc or grinding wheel.
•rated at or above the RPM listed in the "WARNING" section on the tool's nameplate.
•the proper accessory for the job.
WARNING!
To reduce the risk of personal injury and damage to the tool, use ONLY accessories rated at or above the RPM listed on the “WARNING” section of the tool's nameplate.
Installing Backing Pad and Sanding Discs (Fig. 1)
1.Unplug tool and place it upside down on a level surface as shown. Remove any accessories from spindle.
2.Slip backing pad onto spindle with flat side away from gear case. Place sanding disc on backing pad and secure assembly to spindle with disc nut.
3.To tighten, press the spindle lock button while turning disc nut clock- wise.
4.To remove backing pad and sanding disc, unplug tool and reverse procedure.
Fig. 1
Disc Nut
Sanding Disc
Backing Pad
Spindle
Gear Case
Sanding (Fig. 2)
1.Use a clamp, vise or other practical means to hold your work, free- ing both hands to control your tool. Firmly grasp body of tool and side handle before starting and while tool is in operation. Allow sanding disc to come to full speed before beginning to sand.
Sanding Disc and Grinding Wheel Material
Sanding discs and grinding wheels are made of various materials and are designed for different jobs. Be sure that you choose the proper sanding disc or grinding wheel for the job you plan to do.
Selecting Sanding Discs & Grit
Refer to the table below to select the correct type of sanding disc for your job. Generally, use 24 or 36 grit for heavy stock removal; 50, 60, or 80 grit for medium stock removal and 120 grit for finishing. Always begin with a coarse grit, using successively finer grits to obtain the desired finish. See Catalogor a complete list of MILWAUKEE sanding discs.
Aluminum | Aluminum | Ceramic | |
Oxide | Zirconia |
| |
|
|
| |
For fast cutting, gen- | Unique grit pattern is | Lasts up to 3 times | |
eral purpose discs | arranged in clusters | longer than aluminum | |
for most metal jobs. | for faster stock re- | oxide discs. For | |
Best for | moval and cleaning. | general metal work- | |
steel, stainless steel | Ideal | for removing | ing. Ideal for tough |
or metals requiring | paint | from cars, | jobs. |
tough, fast cutting, | boats, etc. without |
| |
long lasting abra- | clogging. |
| |
sives. |
|
|
|
|
|
|
|
2.Hold Sander/Grinder at 5° to 15° angle as shown to ensure proper sanding pressure and control. Too great an angle will result in too much pressure and could cause excessive wear to the disc and workpiece. Too small an angle will reduce control.
3.Use long, sweeping, side to side strokes, advancing forward to produce the desired finish.
Fig. 2
Hold at a 5° to 15° angle
For best result use only this portion of disc
page 5