SET-UP
ATTACH TIP TO GUN
1. Lock gun. See Figure 4.
Locked
Unlocked
Position
Position
Figure 4 - Gun in Locked & Unlocked Position
2.If spray tip is not pre- assembled, (See Figure 5) insert tip (1) into tip guard, (2) and turn 90° coun- terclockwise to spray position (arrow pointing away from gun). Cylinder of tip forms a stop for the seal (3). Insert seal (3) aligning the curve of the seal with the curve of the tip.
3 4
2
Red Seal
1
Figure 5 – Spray Tip Assembly
WARNING POSSIBLE INJECTION 
HAZARD. Do not spray with- out tip guard in place. Never trigger gun unless tip is in the spray or unclog position. Always engage trigger lock
before removing, replacing or cleaning tip.
3.Check seal alignment by removing tip and inspecting tip guard visually, See Figure 6. If needed, remove seal (3) and replace until properly aligned. Replace tip to spray position, (arrow away from gun). Insert red seal (4).
Correct Way | Wrong Way |
Figure 6 - Spray Tip Assembly
4.Attach spray tip to gun. Tighten nut first by hand, then tighten with a wrench. See Figure 7.
Figure 7- Attach Tip to Gun
NOTE: When attaching tip to gun, align tip guard as shown in Figure 8. Then tighten with wrench.
Figure 8 - Vertical Tip Pattern
10