SET-UP
ATTACH RETURN HOSE |
| ATTACH PAINT HOSE |
|
|
|
|
|
|
1.Be sure motor switch is turned OFF.
2.Screw brass fitting of return tube into upper port on side of pump. (The brass fitting is located in the literature set.) Tighten firmly by hand. See figure above.
3.Press return tube (small tube) to brass fitting and fasten with clamp. See Figure 9.
1.Attach high pressure hose to hose port, using an adjustable wrench to tighten firmly. (See illustration above.)
2.Attach gun to other end of high pressure hose. Tighten securely with two adjustable wrenches. See Figure 10.
Figure 10 - Attaching High Pressure Hose to Gun.
Figure 9 - Fastening Return Tube with Clamp
3. Plug unit into a properly grounded outlet or heavy duty grounded extension cord. Do not use more than 100 feet of cord. If you must spray a long distance from a power source, use more paint hose, not more extension cords. Use a minimum size of 16 gauge electric cord for 50 feet;
11