TROUBLE SHOOTING
Problem | Cause | Remedy |
Spray gun won't shut off.
Worn ball or seat.
Foreign matter or paint buildup or dried paint between ball and seat. (Caused by improper cleaning of gun.
Take to Authorized Wagner Service Center.
Take to Authorized Wagner Service Center.
|
| Spray gun leaks. | Worn or dirty internal parts. | Take to Authorized Wagner Service Center. |
|
|
|
|
| (Caused by improper cleaning |
|
|
|
|
|
| of gun.) |
|
|
|
|
|
|
|
|
|
|
|
| Tip assembly leaks | Assembled incorrectly. | Check assembly. |
|
|
|
|
| Worn seal. | Replace seal. |
|
|
|
|
|
|
|
|
|
|
| Spray gun won't spray. | Spray tip, gun filter or tip | Clean spray tip. |
|
|
|
|
| filter plugged. | Clean or replace gun filter. |
|
|
|
|
|
| Clean or replace tip filter. |
|
|
|
|
| Spray tip in Clean position. | Put tip in Spray position. |
|
|
|
|
|
|
|
|
|
|
| Paint tailing. | Pressure is set too low. | Increase pressure. |
|
|
|
|
| Gun, tip,or suction filter plugged. | Clean filters |
|
|
|
|
| Suction tube loose at | Tighten suction tube fitting. |
|
|
|
|
| inlet valve. |
|
|
|
|
|
| Tip worn. | Replace tip. |
|
|
|
|
| Paint too thick | Thin paint |
|
|
|
|
|
|
|
|
|
Thermal overload tripped
WARNING
Follow Pressure Relief Procedure before per- forming any of these operations since the motor will restart with- out warning when the motor cools sufficiently
Motor over heated. | Allow to cool 15 to 30 min. |
Extension cord too long or | Allow to cool, replace cord with one shorter or |
too small gauge. | larger gauge. |
Paint build up on motor. | Clean paint from motor. |
Restart under pressure . | Restart in Prime mode. |
Unit sitting in hot sun. | Move to a shady location. |
27