SM 2610957110
Operation
Sanding curved edges
(Fig. 19 & 20)
1.Always sand inside curves on idler drum as shown in figure 19.
Never attempt to sand the ends of a ! WARNING workpiece on the idler drum.
Applying the end of the workpiece to the idler drum could cause the work piece to fly up and result in an injury.
2. Always sand outside curves on the left hand side of the sanding disc, as shown in figure 20.
Applying the workpiece to the right ! WARNING side of the disc could cause
workpiece to fly up (kickback) and result in injury.
Sanding small end surfaces on the sanding disc (Fig. 21)
1.Use of the mitre gauge is recommended for this operation.
2.Rest the workpiece against the edge of the mitre gauge.
3.Always move the work across the left hand side of the sanding disc.
FIG. 19 |
FIG. 20 |
4. The table may be tilted for bevelled work.
FIG. 21 |
16.