SM 2610957110
Assembly and adjustments
To reduce the risk of injury, never ! WARNING connect plug to power source outlet
until all assembly steps are completed.
Installing sanding disc and guard
(Fig. 2 & 3)
1.Remove the backing from the sanding disc (1). Align perimeter of disc with sanding plate (2) and press disc firmly into position all the way around, as shown in figure 2.
2.Locate disc guard (3) and two M4.2 pan head screws (4).
3.Position disc guard against lower 1/3 of disc aligning holes.
4.Using a Phillips screwdriver, fasten the pan head screws securely, applying light pressure to thread the holes, as shown in figure 3.
5.Adjust the top disc cover (5) for a 1/16” gap. Loosen the two screws, adjust as required, and retighten.
Installing work support (Fig. 4)
1.Using a wrench, secure work support (5) to side of belt & disc sander using M6 hex screw (6), spring lock washer (7) and washer (8), (Figure 4).
2.Hold work support in position and fasten.
To avoid trapping the work or ! WARNING fingers between the work support
and sanding surface, the support edge should be a maximum of
3. Loosen the hex screw of work support, adjust as required, and retighten.
FIG. 2
| 1 | 2 |
|
| |
FIG. 3 |
| 5 |
|
| |
| 3 |
|
| 4 |
|
FIG. 4 |
5 |
7 |
6 |
8 |
9.