! WARNING
Saw Operations
Special Cuts
FIG. 33
Cutting bowed material and round material are only examples of special cuts.
| Cutting Bowed Material | 3 | |
! | WARNING | If workpiece 1 is bowed or warped, clamp | 2 |
it 2 with the outside bowed face toward the |
| ||
fence 3. Always make certain that there is no gap between the | 1 | ||
workpiece, fence and table along the line of cut 4. Bent or | |||
warped workpieces can twist or rock and may cause binding |
| ||
on the spinning saw blade while cutting (Figure 33). |
| ||
Cutting Round or Irregularly Shaped Material
4
For round material 5 such as dowel rods or tubing, always use a clamp 6 or a fixture designed to clamp the workpiece firmly against
the fence 7 and table. Rods have a tendency to roll while being cut, causing the blade to “bite” and pull the work with your hand into the blade (Figure 34).
FIG. 35
6
5
7
68