Skil 52314, 52324, 52318 manual Charging Battery Pack 1 Hour Charger, Important Charging Notes

Page 11

BM 2610916876 11-03 11/19/03 3:02 PM Page 11

CHARGING BATTERY PACK (1 HOUR CHARGER)

Plug charger cord into your standard power outlet. Before inserting battery pack, remove protective cap, then insert battery pack into charger (Fig. 8).

The charger’s green indicator will begin to “BLINK”. This indicates that the battery is receiving a fast charge. Fast-charging will automatically stop when the battery pack is fully charged.

When the indicator light stops “BLINKING” (and becomes a steady green light) fast charging is complete.

When you begin the charging process of the battery pack, a steady green light could also

mean the battery pack is too hot or too cold.

The purpose of the light is to indicate that the battery pack is fast-charging. It does not indicate the exact point of full charge. The light will stop blinking in less time if the battery pack was not completely discharged.

When the battery pack is fully charged, unplug the charger (unless you're charging another battery pack) and slip the battery pack back into the tool handle.

To prevent fire or injury when batteries are not in tool or charger, always place protective cap onto end of battery pack.

FIG. 8

INDICATOR

LIGHT

BATTERY

PACK

CHARGER

PROTECTIVE

CAP

IMPORTANT CHARGING NOTES

1.The battery pack accepts only about 80% of its maximum capacity with its first few charge cycles. However, after the first few charge cycles, the battery will charge to full capacity.

2.The charger was designed to fast charge the battery only when the battery temperature is between 40˚F (4˚C) and 105˚F (41˚C).

3.A substantial drop in operating time per charge may mean that the battery pack is nearing the end of its life and should be replaced.

4.If you anticipate long periods (i.e. a month or more) of non-use of your tool, it is best to run your tool down until it is fully discharged before storing your battery pack. After a long

period of storage, the capacity at first recharge will be lower. Normal capacity will be restored in two or three charge/discharge cycles. Remember to unplug charger during storage period.

5.If battery does not charge properly:

a.Check for voltage at outlet by plugging in some other electrical device.

b.Check to see if outlet is connected to a light switch which turns power “off” when lights are turned off.

c.Check battery pack terminals for dirt. Clean with cotton swab and alcohol if necessary.

d.If you still do not get proper charging, take or send tool, battery pack and charger

-11-

Image 11
Contents Importante For All Battery Operated Tools General Safety RulesService Safety Rules for Cordless JigsawsBattery/Charger NICKEL-CADMIUM Batteries Battery CareSymbols Cordless Jigsaws Functional Description and SpecificationsOperating Instructions AssemblyBlade Orbit Selector Lever Blower Switched onBlower Switched OFF Footplate Angle AdjustmentCircle Cutting Releasing and Inserting Battery PackAttaching Guide Important Charging Notes Charging Battery Pack 1 Hour ChargerAccessories MaintenanceSécurité des personnes Consignes générales de sécurité Pour tous les outils à pileAire de travail Sécurité électriqueRéparation Règles de sécurité concernant les scies sauteusesChargeur de pile Piles NICKEL-HYDRURE DE Métal Piles NICKEL-CADMIUMNOM SymbolesScies sauteuses sans fil Description fonctionnelle et spécificationsConsignes de fonctionnement AssemblageSOUFFLE-COPEAUX À Larrêt Levier Sélecteur Dorbite DE LameSOUFFLE-COPEAUX SOUFFLE-COPEAUX EN MarcheDépose ET Repose DU BLOC-PILES COUPE-CERCLES ET Guide ParallèleMontage DU Guide Découpage DE CerclesRemarques Importantes Concernant LA Charge Charge DU BLOC-PILE Chargeur DE 1 HeureNettoyage AccessoiresService EntretienUtilización y cuidado de las herramientas Area de trabajoSeguridad eléctrica Seguridad personalServicio Normas de seguridad para sierras caladoras sin cordónBatería/cargador Baterías DE NIQUEL-HIDRURO Metalico Cuidado de las bateríasEliminación de las baterías Baterías DE NIQUEL-CADMIODe Ni-Cd SímbolosSierras caladoras sin cordón Descripción funcional y especificacionesInstrucciones de funcionamiento EnsamblajeAjuste DEL Angulo DE LA PLACA-BASE Soplador DE VirutasSoplador Encendido Soplador ApagadoLiberacion E Insercion DEL Paquete DE Baterías Guía DE Corte Circular Y ParaleloColocación DE LA Guía Cortes EN CírculoNotas Importantes Para Cargar Carga DEL Paquete DE Baterías Cargador DE 1 HoraLimpieza MantenimientoAccesorios BM 2610916876 11-03 11/19/03 302 PM Limited Warranty of Bosch Portable and Benchtop Power Tools