Porter-Cable 33-890, 33-892, 33-891, 33-895X Adjusting Table Brackets Parallel to Track ARM

Page 13

ADJUSTING TABLE BRACKETS PARALLEL TO TRACK ARM

To perform accurate work, the track arm must be parallel to the table top brackets at both the front and rear of the machine. To check if the alignment is correct, proceed as follows:

1.Loosen yoke clamp locking lever (A) Fig. 16, pull up yoke clamp index knob (B) and rotate yoke (C) to the out rip position shown in Fig. 17. Tighten yoke clamp locking lever (A).

B

A

C

Fig. 16

B

AC

Fig. 17

2.Place wrench (D) Fig. 18, on flats of arbor and loosen arbor nut (E) using wrench (F).

D

E

F

Fig. 18

13

Image 13

Contents Radial Arm Saw Important Safety Instructions Table of ContentsCalifornia Proposition Safety Guidelines DefinitionsGeneral Safety Rules Avoid Kickback by Additional Safety Rules for Radial ARM SawsMotor Specifications Power ConnectionsThree Phase Operation Grounding InstructionsMinimum Gauge Extension Cord Extension CordsFunctional Description Carton ContentsAssembly Tools Required AssemblyDisconnect Machine from Power Source Guide to PartsAssembling Overarm Elevating Handle Assembling Legs to BaseAssembling Cuttinghead to Track ARM AB CPage Assembling Starter BOX to Base 33-891 and 33-892 Models Adjusting Table Brackets Parallel to Track ARM Page Assembling Table Clamps and Table Clamp Rods Assembling SAW Blade and Blade Guard Assembling Table BoardsOperation Locking Switch in OFF PositionStarting and Stopping SAW Adjusting Yoke Clamp Handle Adjusting Overarm ColumnAdjusting Track Rods Adjusting Cuttinghead Ball Bearings Against Track RodsAdjusting Blade Square with Table TOP Adjusting Track ARM Clamp Handle Adjusting SAW Travel Square with Fence CROSS-CUT Stop Removing Heeling in SAW CUTAdjusting Track ARM Stop Adjusting Blade Guard and ANTI-KICKBACK RODAssembling Accessory Moulding Cutterhead Guard Miter Cutting CROSS-CUTTINGRipping Compound Miter CuttingOUT-RIPPING IN-RIPPINGConstructing a Push Stick PushstickDisconnect Machine from the Power Source Troubleshooting Guide MaintenanceAccessories ServiceWarranty Page Page Canadian PORTER-CABLE Delta Service Centers