Porter-Cable 33-895X, 33-892, 33-890, 33-891 Safety Guidelines Definitions, California Proposition

Page 3

SAFETY GUIDELINES - DEFINITIONS

It is important for you to read and understand this manual. The information it contains relates to protecting YOUR SAFETY and PREVENTING PROBLEMS. The symbols below are used to help you recognize this information.

Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.

Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.

Used without the safety alert symbol indicates potentially hazardous situation which, if not avoided, may result in property damage.

CALIFORNIA PROPOSITION 65

SOME DUST CREATED BY POWER SANDING, SAWING, GRINDING, DRILLING, AND OTHER CONSTRUCTION ACTIVITIES contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:

·lead from lead-based paints,

·crystalline silica from bricks and cement and other masonry products, and

·arsenic and chromium from chemically-treated lumber.

Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, always wear NIOSH/OSHA approved, properly fitting face mask or respirator when using such tools.

3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Radial Arm Saw Important Safety Instructions Table of ContentsCalifornia Proposition Safety Guidelines DefinitionsGeneral Safety Rules Avoid Kickback by Additional Safety Rules for Radial ARM SawsGrounding Instructions Power ConnectionsMotor Specifications Three Phase OperationMinimum Gauge Extension Cord Extension CordsFunctional Description Carton ContentsGuide to Parts AssemblyAssembly Tools Required Disconnect Machine from Power SourceAB C Assembling Legs to BaseAssembling Overarm Elevating Handle Assembling Cuttinghead to Track ARMPage Assembling Starter BOX to Base 33-891 and 33-892 Models Adjusting Table Brackets Parallel to Track ARM Page Assembling Table Clamps and Table Clamp Rods Assembling SAW Blade and Blade Guard Assembling Table BoardsLocking Switch in OFF Position OperationStarting and Stopping SAW Adjusting Yoke Clamp Handle Adjusting Overarm ColumnAdjusting Track Rods Adjusting Cuttinghead Ball Bearings Against Track RodsAdjusting Blade Square with Table TOP Adjusting Track ARM Clamp Handle Adjusting SAW Travel Square with Fence CROSS-CUT Stop Removing Heeling in SAW CUTAdjusting Blade Guard and ANTI-KICKBACK ROD Adjusting Track ARM StopAssembling Accessory Moulding Cutterhead Guard Miter Cutting CROSS-CUTTINGIN-RIPPING Compound Miter CuttingRipping OUT-RIPPINGConstructing a Push Stick PushstickDisconnect Machine from the Power Source Troubleshooting Guide MaintenanceService AccessoriesWarranty Page Page Canadian PORTER-CABLE Delta Service Centers
Top Page Image Contents