Porter-Cable 33-892, 33-890, 33-891 Assembling Table Boards, Assembling SAW Blade and Blade Guard

Page 16

ASSEMBLING TABLE BOARDS

1.Place main table board (A) Fig. 27, on the table mounting brackets making sure that the two roll pins in the table mounting brackets fit into the two holes in bottom of main table board (A). Fasten table in place, place a 1/4" flat washer onto a 1/4-20 x 1-3/4" round head screw and insert the screws through holes (B) predrilled in the main table board (A) and tighten securely.

2.Place the remaining loose boards (C) Fig. 28 and fence (D) on the table mounting brackets, and tighten the two table clamp rod knobs (E). Fence (D) can be repositioned as required.

ASSEMBLING SAW BLADE AND BLADE GUARD

USE ONLY 12” BLADES RATED FOR AT LEAST 3450 RPM.

1. DISCONNECT MACHINE FROM

POWER SOURCE.

2.Remove arbor nut (A) Fig. 29, and outside blade flange (B). NOTE: THE BLADE IS TO BE ASSEMBLED

BETWEEN THE TWO BLADE FLANGES (B) AND (C) WITH THE RECESSED SIDES OF THE FLANGES AGAINST THE SAW BLADE.

3.Assemble the saw blade (D) Fig. 30, between the two blade flanges making sure the teeth of the saw blade are pointing down at the front.

4.Assemble arbor nut (A) Fig. 30 to shaft and tighten with wrench (E) Fig. 30, while keeping arbor shaft from turning with other wrench (F).

A

B

B

Fig. 27

DC

E

E

Fig. 28

C

B

A

Fig. 29

D

A

E

F

Fig. 30

16

Image 16

Contents Radial Arm Saw Table of Contents Important Safety InstructionsSafety Guidelines Definitions California PropositionGeneral Safety Rules Additional Safety Rules for Radial ARM Saws Avoid Kickback byPower Connections Motor SpecificationsThree Phase Operation Grounding InstructionsExtension Cords Minimum Gauge Extension CordCarton Contents Functional DescriptionAssembly Assembly Tools RequiredDisconnect Machine from Power Source Guide to PartsAssembling Legs to Base Assembling Overarm Elevating HandleAssembling Cuttinghead to Track ARM AB CPage Assembling Starter BOX to Base 33-891 and 33-892 Models Adjusting Table Brackets Parallel to Track ARM Page Assembling Table Clamps and Table Clamp Rods Assembling Table Boards Assembling SAW Blade and Blade GuardOperation Locking Switch in OFF PositionStarting and Stopping SAW Adjusting Overarm Column Adjusting Yoke Clamp HandleAdjusting Cuttinghead Ball Bearings Against Track Rods Adjusting Track RodsAdjusting Blade Square with Table TOP Adjusting Track ARM Clamp Handle Adjusting SAW Travel Square with Fence Removing Heeling in SAW CUT CROSS-CUT StopAdjusting Track ARM Stop Adjusting Blade Guard and ANTI-KICKBACK RODAssembling Accessory Moulding Cutterhead Guard CROSS-CUTTING Miter CuttingCompound Miter Cutting RippingOUT-RIPPING IN-RIPPINGPushstick Constructing a Push StickTroubleshooting Guide Maintenance Disconnect Machine from the Power SourceAccessories ServiceWarranty Page Page Canadian PORTER-CABLE Delta Service Centers