Porter-Cable 33-891, 33-892 Assembling Legs to Base, Assembling Overarm Elevating Handle, Ab C

ASSEMBLING LEGS TO BASE

Mechanically lift the machine using a forklift and lifting straps to support the machine. The four steel legs should be attached to each corner of the base using sixteen 5/16-18 x 5/8" carriage head screws (A) Fig. 4A and Fig. 4B, 5/16" flat washers (B), 5/16" lockwashers (C) and 5/16" hex nuts (D).

ASSEMBLING OVERARM ELEVATING HANDLE

1.Insert shear pin (A) Fig. 5, into the hole in elevating shaft (B). Using a hammer, tap this pin in to place as show in Fig. 5.

2.Line up the slots in elevating handle (C) Fig. 5, with shear pin (A) and place handle on shaft (B) making certain the roll pin is engaged in the slots.

3.Fasten elevating handle (C) Fig. 6, to shaft (B) with a 1/4"-20 x 1/2" hex head screw (D) and 1/4" flat washer

(E).

A

D

B C

Fig. 4A

AB C

Fig. 4B

C

AB Fig. 5

D

ASSEMBLING CUTTINGHEAD TO TRACK ARM

1.Raise the track arm assembly (A) Fig. 7, by turning overarm elevating handle (F) Fig. 2.

2.Remove packing material from around cuttinghead assembly (B) Fig. 7.

C

B

E

D

Fig. 6

C

F

E

D

A

B

Fig. 7

10