Porter-Cable 33-892, 33-890, 33-891, 33-895X instruction manual Adjusting Blade Square with Table TOP

Page 20

ADJUSTING BLADE SQUARE WITH TABLE TOP

The saw blade must be square with the table top in order to produce accurate work. To check if the blade is square with the table:

1. DISCONNECT MACHINE FROM

POWER SOURCE.

2.Remove the blade guard and place the cuttinghead in a cross-cut position as shown in Fig. 42.

3.Place a steel square (A) Fig. 42, against saw blade

(B) and table, and check to see if the blade (B) is square with the table. Make certain the square is between the teeth of the saw blade.

4.If the blade is not square with the table an adjustment is necessary. Loosen two bolts (C) Fig. 43.

5. Loosen screw (D) Fig. 44, located inside of yoke (E).

6.Hold cuttinghead with left hand as shown in Fig. 45, loosen bevel clamp handle (F) and tilt the motor until the saw blade is flush against the square.

A

B

Fig. 42

C

Fig. 43

E

D

Fig. 44

F

Fig. 45

20

Image 20

Contents Radial Arm Saw Table of Contents Important Safety InstructionsSafety Guidelines Definitions California PropositionGeneral Safety Rules Additional Safety Rules for Radial ARM Saws Avoid Kickback byPower Connections Motor SpecificationsThree Phase Operation Grounding InstructionsExtension Cords Minimum Gauge Extension CordCarton Contents Functional DescriptionAssembly Assembly Tools RequiredDisconnect Machine from Power Source Guide to PartsAssembling Legs to Base Assembling Overarm Elevating HandleAssembling Cuttinghead to Track ARM AB CPage Assembling Starter BOX to Base 33-891 and 33-892 Models Adjusting Table Brackets Parallel to Track ARM Page Assembling Table Clamps and Table Clamp Rods Assembling Table Boards Assembling SAW Blade and Blade GuardStarting and Stopping SAW Locking Switch in OFF PositionOperation Adjusting Overarm Column Adjusting Yoke Clamp HandleAdjusting Cuttinghead Ball Bearings Against Track Rods Adjusting Track RodsAdjusting Blade Square with Table TOP Adjusting Track ARM Clamp Handle Adjusting SAW Travel Square with Fence Removing Heeling in SAW CUT CROSS-CUT StopAssembling Accessory Moulding Cutterhead Guard Adjusting Blade Guard and ANTI-KICKBACK RODAdjusting Track ARM Stop CROSS-CUTTING Miter CuttingCompound Miter Cutting RippingOUT-RIPPING IN-RIPPINGPushstick Constructing a Push StickTroubleshooting Guide Maintenance Disconnect Machine from the Power SourceWarranty ServiceAccessories Page Page Canadian PORTER-CABLE Delta Service Centers