3.Push track arm clamp lever (C) Fig. 7, to the rear until it rests against stop (D) as shown.
4.Pull out on track arm index knob (E) Fig. 7, and rotate track arm (F) 90° to the position shown in Fig. 8. Tighten track arm clamp lever (C) Fig. 8, by pulling it to front position.
5.Unscrew and remove blade guard clamping rod and washer (G) Fig. 9, and remove blade guard assembly (H).
6.Place cuttinghead clamp (J) Fig. 10, in slot on top of cuttinghead. NOTE: Jaws of cuttinghead clamp must be open as shown.
7.Lift cuttinghead assembly (B) Fig. 11, and insert roller bearings (K) into track arm assembly (A) as shown. NOTE: Make certain the roller bearings (K) are riding on track rods (L). Push cuttinghead assembly (B) Fig. 11, into track arm assembly (A) and tighten cuttinghead clamp (J) Fig. 11.
C
F
Fig. 8
G
H
Fig. 9
A
J
B
L K L
Fig. 11
J
Fig. 10
11