Precor C936i owner manual Secure the display console to the upright supports. Diagram, Csafe

C O M M E R C I A L P R O D U C T S D I V I S I O N

8.Attach the left side upright support to the base assembly. Refer to Diagram 6. Align the upright support with the base assembly mounting bracket and secure it by following steps 7a and 7b.

Diagram 7	Install the
	display console.

Display console

Display console mounting brackets

Upright support

9.Secure the display console to the upright supports. Diagram 7.

a.Make sure that the cable is routed through the top of the upright support. Have an assistant hold onto the cable (see inset).

Diagram 8	Secure the	1
	display console.
	CSAFE
	receptacle
	Cable receptacle
	Display console	2
	1-inch screws (G)
	with washers (D)
	Tighten the
	screws, but	3
	leave room for
	adjustments.

b.Align the display console with the upright support mounts. Insert two 1-inch screws (G) with washers (D) and finger tighten. Do the same for the oppo- site upright support. Do not fully tighten the screws. Refer to Diagram 8, #1.

c.Attach the cable connector by sliding it into its receptacle underneath the console. A definite “click” is heard when the cable is properly attached. Refer to Diagram 8, #2. If you do not hear and feel the connector “snap” into place, reinsert it.

Important: Do not use the receptacle covered by the plastic plug.This CSAFE receptacle is for a separate option.

d.So that the cable does not hang below the console, slide it into the clip found underneath the console. Refer to Diagram 8, #3.

page 14