C O M M E R C I A L P R O D U C T S D I V I S I O N
To access the Club settings, the following must occur:
❑Check to be sure that the treadmill is turned ON.
❑Check that the Precor banner appears on the display.
❑Press the appropriate key sequences. (To cancel entries, press RESET.)
The display console keys that you need to press to select the units of measure or set the maximum speed, workout, and pause times are as follows:
Stop, QUICKSTART, ENTER, QUICKSTART, INCLINE ▲, QUICKSTART, ENTER, QUICKSTART
Note: To initiate the Club Custom mode, you need to press QUICKSTART within 1/3 second after pressing the Stop button. (The RESET key may be used in place of the Stop button.)
Important: To access Club Custom mode, press Stop while the Precor banner is displayed.Within ¹⁄₃ second, begin pressing the key sequences.If the system does not detect a key press (within ¹⁄₃ second) after Stop, it resets to the Precor banner.When you begin entering a key sequence, each key must be pressed within four seconds of the other or the Precor banner reappears and you have to begin again.
Display key functions within the Club Custom Mode
▼▲ lets you scroll through the various selections that appear. The longer the key is held down, the faster the numbers scroll past.
Stop advances to the next aspect of the program without storing the information that appears on the display.
SELECT | reminds you what part of |
| the program you’re changing. |
RESET | exits Club Custom mode and |
| displays the Precor banner. |
ENTER | saves the information being |
| displayed and moves to the |
| next aspect of the program. |
DETERMINING THE UNITS OF MEASURE
Two different units of measure can be selected, Metric or U.S. standard. Make your selection using the ▼▲ keys. Press ENTER once the correct unit is displayed.
Note: Anytime you wish to exit the Club Custom mode, press the RESET key. The display attributes that you selected by pressing ENTER are saved and recorded in memory.
CAUTION: If you change the Unit of Measure display, be sure to check the “Set Max Speed” setting to verify that it is correct. Refer to Determining the Club Speed Limit.
page 24
