Precor C936i owner manual First Tighten

C O M M E R C I A L P R O D U C T S D I V I S I O N

Diagram 15	Secure the
	fasteners.
	Second:
	Alternately	2
	tighten four side
	upright screws.

First: Alternately tighten four front panel screws.

Third: Alternately
tighten the four
screws that
secure the	1
console to the
uprights.

3

17.Tighten all mounting screws with the hex key (H) provided. Diagram 15. Start at the front of the treadmill with the four screws that attach the upright supports to the front panel. See Diagram 15, #1. Tightening these screws first helps pull the rest of the treadmill’s parts into alignment. Second, proceed with tightening the four screws (A) that secure the upright supports. See Diagram 15, #2. Third, tighten the four console assembly screws (C). See Diagram 3, #3.

Important: For proper alignment, it is critical that the fasteners are tightened in the order shown in Diagrams 15 and 16.

Diagram 16	Tighten the	1	2
	handrail
	fasteners.
	First: Tighten
	the handrail
	clamp screws.
	Second:
	Tighten the
	side bracket		3
	screws.
	Third: Tighten
	the lower
	handrail
	screws.

18.Tighten all the handrail mounting screws. Diagram 16. So that you don’t overtighten the fasteners, hold the supplied hex key by its 3-inch section and tighten all six handrail clamp screws. See Diagram 16, #1. Next, tighten the two side bracket screws. Because of inaccessibility, hold the 10-inch section of the hex key to tighten the four lower handrail screws.

page 19