Porter-Cable 33-895X, 33-892, 33-890, 33-891 Assembling Table Clamps and Table Clamp Rods

Page 15

7.If an adjustment is necessary, remove screw (R) Fig. 23, loosen locknut (S) and turn leveling screw (T) to raise or lower table mounting bracket (N). When adjust- ment is complete, tighten locknut (S) and replace screw

(R).

8.Check and adjust the other table mounting bracket in the same manner. IMPORTANT: Do not raise or lower the track arm assembly while checking or making the ad- justments.

9.Place a straight edge (V) Fig. 24, on table mounting brackets (N) as shown and adjust two center positions

(W) if necessary in the same manner on both brackets.

ASSEMBLING TABLE CLAMPS AND TABLE CLAMP RODS

1.Unscrew the metal clamps from the table clamp rods packed with the saw.

2.Position the metal clamp (A) Fig. 25, on the end of table mounting bracket (B). NOTE: Assemble metal clamp (A) so threaded hole (C) is on the inside of table mounting bracket.

3.Insert threaded end of table clamp rod (D) Fig. 26, through metal support (E) at the front of the saw and thread rod through the tapped hole in table clamp (A) as shown.

4.Assemble the remaining table clamp and table clamp rod to the other side of the table in the same manner. Do not tighten the table clamp rods at this time.

R

N

T

S

Fig. 23

NV

NW

Fig. 24

B A

C

Fig. 25

AD

E

Fig. 26

15

Image 15

Contents Radial Arm Saw Important Safety Instructions Table of ContentsCalifornia Proposition Safety Guidelines DefinitionsGeneral Safety Rules Avoid Kickback by Additional Safety Rules for Radial ARM SawsGrounding Instructions Power ConnectionsMotor Specifications Three Phase OperationMinimum Gauge Extension Cord Extension CordsFunctional Description Carton ContentsGuide to Parts AssemblyAssembly Tools Required Disconnect Machine from Power SourceAB C Assembling Legs to BaseAssembling Overarm Elevating Handle Assembling Cuttinghead to Track ARMPage Assembling Starter BOX to Base 33-891 and 33-892 Models Adjusting Table Brackets Parallel to Track ARM Page Assembling Table Clamps and Table Clamp Rods Assembling SAW Blade and Blade Guard Assembling Table BoardsLocking Switch in OFF Position OperationStarting and Stopping SAW Adjusting Yoke Clamp Handle Adjusting Overarm ColumnAdjusting Track Rods Adjusting Cuttinghead Ball Bearings Against Track RodsAdjusting Blade Square with Table TOP Adjusting Track ARM Clamp Handle Adjusting SAW Travel Square with Fence CROSS-CUT Stop Removing Heeling in SAW CUTAdjusting Blade Guard and ANTI-KICKBACK ROD Adjusting Track ARM StopAssembling Accessory Moulding Cutterhead Guard Miter Cutting CROSS-CUTTINGIN-RIPPING Compound Miter CuttingRipping OUT-RIPPINGConstructing a Push Stick PushstickDisconnect Machine from the Power Source Troubleshooting Guide MaintenanceService AccessoriesWarranty Page Page Canadian PORTER-CABLE Delta Service Centers