Outback Power Systems FX 2024 T installation manual Turbo FAN Cover FX-DCC DC Compartment Cover

Page 11

FX PARTS AND ACCESSORIES

TURBO FAN COVER

FX-DCC (DC COMPARTMENT COVER)

Covers the DC terminal area and provides space to mount other components such as a DC current shunt

(can be used with or without the FX-DCA).

FX-DCA (DC CONDUIT ADAPTER)

FX-ACA (AC CONDUIT ADAPTER)

• Allows the connection of two-inch TSC (Traffic

• Extends the AC wiring compartment

Signal Conduit) to the FX

• Connects to OutBack’s FLEXware enclosures

• Connects to OutBack’s FLEXware enclosures

• Protects and secures conduit and cables

 

• Allows for AC breakers and GFCI mounting

AC CONDUIT PLATE

BATTERY TERMINAL COVERS

• AC conduit connects to the AC Conduit Plate for

• The caps are made of stiff plastic with a snap-on de-

installations which do not utilize an ACA.

sign; remove them carefully using a flat-blade screw-

 

driver inserted into the slots on the sides of each cover.

 

• DC conduit may be required for exposed installations.

 

FX-DCA and FX-ACA cover options allow conduit con-

 

nection.

 

• Always keep the battery terminal covers installed.

8

Image 11
Contents FX and VFX Series INVERTER/CHARGER Page Warranty Introduction Table of Contents FX Series Inverter/Charger Models Initial Inspection Important Safety InstructionsGenerate Explosive Gases During Normal Operation Personal PrecautionsSystem Protection DC Wiring OriginationAC Wiring Compartment Board AC Wiring OriginationAC and DC Grounding Requirements FX-DCA DC Conduit Adapter AC Conduit Plate Battery Terminal CoversTurbo FAN Cover FX-DCC DC Compartment Cover Mounting LOW Voltage Terminals Control Terminal Wiring Block JumperFollow these steps to wire the FX to your system Wire ConnectionsConnection Torque in Pound Measures Torque RequirementsChassis Ground AC Wiring Notes for the NON-MOBILE FXAC HOT OUT AC Neutral OUT/AC NeutralAC Neutral OUT/AC Neutral AC Wiring Notes for the Mobile FXInverter and ON/OFF LOW-VOLTAGE WiringAuxiliary Output AUX + / AUX RJ-45 jack connects Mate or HUB to FX using CAT5 cable RTS, MATE/HUB WiringSingle FX System Sample InstallationsSeries or SERIES/PARALLEL Dual FX Configuration Series/Parallel Using Two FXs Series/Parallel Using Four FXs Paralleled Dual FX System SERIES/PARALLEL Quad FX System Phase FX System Three-Phase System Generator Auto Start Mobile FX Information GENMate HUB Installation Check ListMaximum DC Input Current Appendix RatingsNominal AC Output Voltage of AN FX System Recommended FX DC Voltage RangeMaximum AC Input Current Maximum Current for Battery ChargerRated DC Input Current AC Input Operating Voltage RangeMaximum AC Output Current Maximum Continuous Output PowerAC Input Frequency Range Maximum Overcurrent Protection Ampacity Wire SizesMaintenance OutBack Power Systems Two Year Limited Warranty WarrantyProduct Registration Extended Warranty Application U.S. and Canada only