Outback Power Systems FX 2024 T installation manual LOW-VOLTAGE Wiring, Inverter and ON/OFF

Page 18

LOW-VOLTAGE WIRING

This six-position terminal block can be unplugged to make wiring easier and to simplify the removal and reinstallation of an FX. It must be securely and completely plugged in for proper FX functioning. Otherwise, operational errors can occur.

Control Wiring Terminal Block

12 VDC at 0.7 amps (8.4 w) is available at the AUX+/AUX- terminals

A switch can be wired to the INVERTER and ON/OFF terminals to manually control the FX

XCT+/XCT- are not operational

��

��

��

��

��

��

��

��

��

��

��

��

��
��
��	��	��	��

INVERTER and ON/OFF

•Replacing the pre-installed jumper connecting the ON/OFF terminals with a switch allows manual control of the FX.

•Without an ON/OFF switch, the inverter(s) will always be ON.

•Cycling the switch again returns the inverter to the ON mode.

INVERTER ON/OFF

Control Wiring Terminal Block, side view

Jumper

15

Image 18

Contents FX and VFX Series INVERTER/CHARGER Page Warranty Introduction Table of Contents FX Series Inverter/Charger Models Important Safety Instructions Initial InspectionPersonal Precautions Generate Explosive Gases During Normal OperationDC Wiring Origination System ProtectionAC Wiring Origination AC Wiring Compartment BoardAC and DC Grounding Requirements AC Conduit Plate Battery Terminal Covers Turbo FAN Cover FX-DCC DC Compartment CoverFX-DCA DC Conduit Adapter Mounting Control Terminal Wiring Block Jumper LOW Voltage TerminalsWire Connections Follow these steps to wire the FX to your systemTorque Requirements Connection Torque in Pound MeasuresAC Neutral OUT/AC Neutral AC Wiring Notes for the NON-MOBILE FXAC HOT OUT Chassis GroundAC Wiring Notes for the Mobile FX AC Neutral OUT/AC NeutralLOW-VOLTAGE Wiring Inverter and ON/OFFAuxiliary Output AUX + / AUX RTS, MATE/HUB Wiring RJ-45 jack connects Mate or HUB to FX using CAT5 cableSample Installations Single FX SystemSeries or SERIES/PARALLEL Dual FX Configuration Series/Parallel Using Two FXs Series/Parallel Using Four FXs Paralleled Dual FX System SERIES/PARALLEL Quad FX System Phase FX System Three-Phase System Generator Auto Start GEN Mobile FX InformationInstallation Check List Mate HUBRecommended FX DC Voltage Range Appendix RatingsNominal AC Output Voltage of AN FX System Maximum DC Input CurrentAC Input Operating Voltage Range Maximum Current for Battery ChargerRated DC Input Current Maximum AC Input CurrentMaximum Continuous Output Power AC Input Frequency RangeMaximum AC Output Current Wire Sizes Maximum Overcurrent Protection AmpacityMaintenance Warranty OutBack Power Systems Two Year Limited WarrantyExtended Warranty Application U.S. and Canada only Product Registration