Outback Power Systems FX 2024 T AC Wiring Notes for the NON-MOBILE FX, Ac Hot Out, Chassis Ground

Page 16

AC WIRING NOTES FOR THE NON-MOBILE FX

AC HOT OUT

• AC hot output conductor (black) wire

gauge must be sized to the breakers and

 

loads.

 

AC NEUTRAL OUT/AC NEUTRAL IN

����������

 

Both neutral terminals are common with each other within the FX.

Only one neutral needs to connect at the terminal if a separate common neutral bus bar is installed.

CHASSIS GROUND

Both CHASSIS GROUND terminals are common within the FX.

The AC input and AC output ground wires can connect to these terminals or one can be connected if a common ground bus bar is installed.

AC HOT IN

The AC hot input conductor (black) must be supplied through a 60 amp maximum AC branch rated circuit breaker.

6 AWG wire is required for the FX’s AC transfer switch.

��������������

�����������������

�����������������

 

�������������

 

 

 

���������

 

 

��������������� ��������

������ ����

����

����

����

 

������������

 

 

 

��������

 

 

 

�������

���� ��

���

������ ��������

�����

�����

13

Image 16
Contents FX and VFX Series INVERTER/CHARGER Page Warranty Introduction Table of Contents FX Series Inverter/Charger Models Important Safety Instructions Initial InspectionPersonal Precautions Generate Explosive Gases During Normal OperationDC Wiring Origination System ProtectionAC Wiring Origination AC Wiring Compartment BoardAC and DC Grounding Requirements Turbo FAN Cover FX-DCC DC Compartment Cover AC Conduit Plate Battery Terminal CoversFX-DCA DC Conduit Adapter Mounting Control Terminal Wiring Block Jumper LOW Voltage TerminalsWire Connections Follow these steps to wire the FX to your systemTorque Requirements Connection Torque in Pound MeasuresAC Wiring Notes for the NON-MOBILE FX AC HOT OUTAC Neutral OUT/AC Neutral Chassis GroundAC Wiring Notes for the Mobile FX AC Neutral OUT/AC NeutralLOW-VOLTAGE Wiring Inverter and ON/OFFAuxiliary Output AUX + / AUX RTS, MATE/HUB Wiring RJ-45 jack connects Mate or HUB to FX using CAT5 cableSample Installations Single FX SystemSeries or SERIES/PARALLEL Dual FX Configuration Series/Parallel Using Two FXs Series/Parallel Using Four FXs Paralleled Dual FX System SERIES/PARALLEL Quad FX System Phase FX System Three-Phase System Generator Auto Start GEN Mobile FX InformationInstallation Check List Mate HUBAppendix Ratings Nominal AC Output Voltage of AN FX SystemRecommended FX DC Voltage Range Maximum DC Input CurrentMaximum Current for Battery Charger Rated DC Input CurrentAC Input Operating Voltage Range Maximum AC Input CurrentAC Input Frequency Range Maximum Continuous Output PowerMaximum AC Output Current Wire Sizes Maximum Overcurrent Protection AmpacityMaintenance Warranty OutBack Power Systems Two Year Limited WarrantyExtended Warranty Application U.S. and Canada only Product Registration