Outback Power Systems FX 2024 T installation manual Installation Check List, Mate HUB

Page 31

INSTALLATION CHECK LIST

ITEM

YES

NO

All manuals read and reviewed?

FX

OutBack Charge Controller

MATE

HUB

System mounted with the recommended number and sized fasteners?

System installed according to National Electrical Code (NEC) and local codes?

System inspected?

System permanently grounded?

Did the installer use OutBack recommended wire type and gauge adjusted for temperature ratings and length?

All AC wiring rated for 75° C or higher?

Battery cables rated 75° C or higher?

6 AWG wire used for non-Mobile FX AC Input Hot?

10 AWG or larger wire used for AC HOT OUT?

10 AWG wire or larger used for Mobile FX AC Input Hot?

Non-Mobile FX connected to AC circuit with 60 amp maximum branch-circuit over-current protection?

Mobile FX connected to AC circuit with 30 amp maximum branch-circuit over-current protection?

All cables torqued to OutBack specifications?

AC and PV breakers to 22 inch-lbs?

All DC connections to 10 foot-lbs?

FX AC terminals to 30 inch-lbs?

FX battery breaker to 45 inch-lbs?

All terminal block screws torqued to 2.5 foot-lbs?

28

Image 31

Contents FX and VFX Series INVERTER/CHARGER Page Warranty Introduction Table of Contents FX Series Inverter/Charger Models Initial Inspection Important Safety InstructionsGenerate Explosive Gases During Normal Operation Personal PrecautionsSystem Protection DC Wiring OriginationAC Wiring Compartment Board AC Wiring OriginationAC and DC Grounding Requirements Turbo FAN Cover FX-DCC DC Compartment Cover AC Conduit Plate Battery Terminal CoversFX-DCA DC Conduit Adapter Mounting LOW Voltage Terminals Control Terminal Wiring Block JumperFollow these steps to wire the FX to your system Wire ConnectionsConnection Torque in Pound Measures Torque RequirementsChassis Ground AC Wiring Notes for the NON-MOBILE FXAC HOT OUT AC Neutral OUT/AC NeutralAC Neutral OUT/AC Neutral AC Wiring Notes for the Mobile FXInverter and ON/OFF LOW-VOLTAGE WiringAuxiliary Output AUX + / AUX RJ-45 jack connects Mate or HUB to FX using CAT5 cable RTS, MATE/HUB WiringSingle FX System Sample InstallationsSeries or SERIES/PARALLEL Dual FX Configuration Series/Parallel Using Two FXs Series/Parallel Using Four FXs Paralleled Dual FX System SERIES/PARALLEL Quad FX System Phase FX System Three-Phase System Generator Auto Start Mobile FX Information GENMate HUB Installation Check ListMaximum DC Input Current Appendix RatingsNominal AC Output Voltage of AN FX System Recommended FX DC Voltage RangeMaximum AC Input Current Maximum Current for Battery ChargerRated DC Input Current AC Input Operating Voltage RangeAC Input Frequency Range Maximum Continuous Output PowerMaximum AC Output Current Maximum Overcurrent Protection Ampacity Wire SizesMaintenance OutBack Power Systems Two Year Limited Warranty WarrantyProduct Registration Extended Warranty Application U.S. and Canada only