Grizzly G0652, G0651 owner manual Riving Knife Table Insert, To install the riving knife

Riving Knife Table Insert

Review this section, even if your saw riving knife came pre-installed. You must install the riving knife or the splitter and blade guard before operat- ing the table saw.

To install the riving knife:

1.DISCONNECT THE SAW FROM POWER!

2.Put on heavy leather gloves.

3.Remove the table insert, blade guard, and splitter—if previously installed.

4.Loosen the hex bolt (Figure 25), insert the riving knife into the bracket slot, and tighten the hex bolt to secure the riving knife.

Riving Knife

Bracket

Hex Bolt

Figure 25. Riving knife installed.

5.Install the table insert, as described in Table

Insert.

G0651/G0652 10" Extreme Series Table Saws

You must install the table insert before operating the table saw.

To install and adjust the table insert:

1.DISCONNECT THE SAW FROM POWER!

2.Place the table insert into the table, then place a straightedge across the table and the table insert.

3.Use a 3mm hex wrench and straightedge to adjust the table insert flush with the table as shown in Figure 26.

Figure 26. Adjusting the table insert.

The table insert must be flush with the table top or the workpiece will hit the edge of the table insert at the beginning of the cut.

4.Tighten the M5-.8 x 20 flat head screw shown in Figure 27.

Table Insert

Screw

Figure 27. Table insert screw.

Note: Do not overtighten the table insert screw. If you have questions, contact Technical Support.

-25-