Grizzly G0651, G0652 owner manual

6.Fasten the 79" rear rail to the extension table with three M8-1.25 x 25 cap screws, three lock washers, six flat washers, and three hex nuts, as shown in Figure 15. Finger tighten for now.

x 3

Figure 15. Rear rail/table fastener locations.

7.Align the table and extension table with a straightedge (Figure 16), then tighten the fasteners in Figure 14 with a 5mm hex wrench and 13mm wrench.

Figure 16. Aligning main extension table.

8.Repeat the aligning procedure and tighten the fasteners in Figure 15 with a 6mm hex wrench and 13mm wrench.

9.Tighten the cap screws shown in Figure 13.

10.Install each foot with a 3⁄8-16 hex nut onto into the bottom of a support leg, as shown in

Figure 17.

-22-

Support Leg

Hex Nut Foot

Figure 17. Foot installed on support leg.

11.Fasten each support leg to the main exten- sion table with four M6-1 x 12 Phillips head screws and flat washers, as shown in Figure 18.

x 4

Figure 18. Support leg fastened to main

extension table.

12.Rotate both feet until they touch the ground, and tighten the hex nuts against the support legs to secure the feet.

G0651/G0652 10" Extreme Series Table Saws