Grizzly G0651, G0652 owner manual Combination blade features, Dado Blades, Laminate blade features

Combination blade features:

•Adequate for cutting both with and across the grain.

•40-50 teeth.

•Alternate top bevel and flat, or alternate top bevel and raker tooth profile.

•Teeth are arranged in groups of five.

•Gullets are small and shallow within the groups of five teeth, similar to a cross-cut blade; then large and deep between each group of five, like a ripping blade.

6aiZgcViZ

Ide

7ZkZa

VcY ;aVi

Dado Blades:

There are two types of dado blades: stacked and wobble.

•Stacked Dado Blade: These dedicated dado cutting blade sets consist of up to 8 indi- vidual blades. Multiple cutters are "stacked" between two outside blades. The width of the dado is determined by the combination of cutters that are “stacked” together. The dado is cut in a single pass leaving a smooth and square channel in the face of the workpiece. Stacked dado blades are the most expen- sive option, but are worth considering if your projects require a lot of visible dado cuts. A stacked dado blade is shown in Figure 40.

Figure 38. Combination blade.

Laminate blade features:

•Best for cutting plywood or veneer.

•40-80 teeth.

•Triple chip tooth profile.

•Very shallow gullet.

Ig^eaZ

8]^e

7aVYZ

Figure 39. Laminate blade.

-32-

Figure 40. Stacked dado blade.

•Wobble Dado Blade: Also a dedicated dado blade, a wobble blade usually consists of a single blade that is tilted on the arbor shaft while it is spinning. The channel is cut in the face of the workpiece as the blade pass- es through its pre-adjusted width of travel. Wobble blades are an inexpensive option when visibly pleasing channels are not a con- cern.

G0651/G0652 10" Extreme Series Table Saws