SECTION 2: CIRCUIT REQUIREMENTS
110/220V Single-
Phase (G0613)
The Model G0613 is prewired for 110V opera- tion. If you plan to use your machine at 220V, you must rewire the motor. Refer to the wiring diagram and consult a qualified electrician.
Amperage Draw
The Model G0613 features a 110/220V motor that is prewired for 110V and draws the following amps under maximum load:
Motor Draw at 220V | .............................7.7 | Amps |
Motor Draw at 110V | 15.4 | Amps |
Circuit Requirements
We recommend connecting your machine to a dedicated and grounded circuit that is rated for the amperage given below. Never replace a circuit breaker on an existing circuit with one of higher amperage without consulting a qualified electri- cian to ensure compliance with wiring codes. If you are unsure about the wiring codes in your area or you plan to connect your machine to a shared circuit, consult a qualified electrician.
110V Circuit | 20 Amps |
220V Circuit | 15 Amps |
220V Connection
Rewire the motors according to the wiring con- nection diagram on the inside cover of the motor and pump junction boxes. Refer to G0613 Single Phase 220V Wiring Diagram on Page 46 for general wiring details. Also use the following 220V plug for your machine on a dedicated circuit (see Figure 4):
220V Plug & Receptacle |
Electrocution or fire could result if this machine is not grounded correctly or if your electrical configu- ration does not comply with local and state codes. Ensure compliance by checking with a qualified electrician!
Figure 4. Recommended 220V 6-15
outlet and plug.
Extension Cords
Using extension cords may reduce the life of the motor. Instead, place the machine near a power source. If you must use an extension cord:
•For 110V, use at least a 12 gauge cord that does not exceed 50 feet in length.
•For 220V, use at least a 14 gauge cord that does not exceed 50 feet in length.
•Ensure that the extension cord contains a ground wire and plug pin.
G0613/14 Swivel Mast Metal Cutting Bandsaw