Grizzly G0514 owner manual START/STOP Switch Guide Post, To adjust guide post

The START/STOP switch on the Model G0513/ G0514 is located on the column for easy access (Figures 35). Immediately turn the machine OFF if there is a safety hazard.

Figure 35. G0513 START/STOP switch.

-28-

The guide post, shown in Figure 36, connects the upper blade guide assembly to the bandsaw. The guidepost allows the blade guide assembly to move up or down via a rack and pinion. In order to cut accurately, the blade guide assembly must be no more than 1" from the top of the workpiece at all times—this positioning provides the best support for the blade.

Guide Post

Lock Knob

Guide Post

Handwheel

Figure 36. Guide post controls.

To adjust guide post:

1.Make sure that the blade tension, blade tracking, support bearing, and blade guides are adjusted correctly.

2. Loosen the guide post lock knob shown in Figure 36.

3. Turn the guide post handwheel to raise or lower the guide post until the upper blade guide assembly is within 1" from the top of the workpiece.

4. Lock the guide post in place with the lock knob.

Model G0513/G0514 (Mfg. 8/02+)