Grizzly G0514 owner manual 7gVX`Zi Hb6 JYZ

6.Place the guide post guard on top of the guide post assembly so you can access the guide post bracket.

7.Loosen the four screws shown in Figure 67 enough to fit metal shims between the frame and the guide post bracket (see Figure 69).

—If the guide post to blade distance is greater at the bottom than at the top, place a shim between the bottom of the bracket and the frame (Shim "A"). This will tilt the bottom of the guide post toward the blade.

—If the guide post to blade distance is less at the bottom than at the top, place a shim between the top of the bracket and the frame (Shim "B"). This will tilt the bottom of the guide post away from the blade.

H]^b7

;gVbZ	<j^YZ		AZ[iH^YZK^Zl	7aVYZ
	7gVX`Zi
		H]^b6
	<j^YZ
	Edhi

Figure 69. Location for placing shims.

8.Tighten the four screws shown in Figure 67, then repeat Steps 4–5.

—If the measurements are equal, go to Step 9.

—If the measurements are not equal, con- tinue adding shims as needed until guide post rack to blade distance is the same at the top and bottom.

9.Reinstall the guide post guard with the screws removed in Step 3.

-52- Model G0513/G0514 (Mfg. 8/02+)