Grizzly G0444Z instruction manual Beginning Assembly Stand, Tools Needed

Beginning Assembly Stand

This section will cover the basic assembly and adjustment instructions needed to begin opera- tion. Complete the assembly in the order provid- ed in this manual and then read the remaining portion of the manual before attempting any type of operation.

Your safety is important! Please follow the warnings below during this entire section:

Loose hair and clothing could get caught in machinery and cause serious personal injury. Keep loose clothing rolled up and long hair tied up and away from machinery.

!Disconnect power to the machine during the

entire assembly process. Failure to do this may result in seri- ous personal injury.

Sharp edges on metal parts may cause person- al injury. Examine the edges of all metal parts before handling.

-18-

Components and Hardware Needed:		Qty
Saw		1
Stand Legs		4
Side Supports
¥	Long Flat	2
¥	Long Short	2
¥	Long ÒLÓ	2
¥	Short ÒLÓ	2
Carriage Bolts 5Ú16"-18 x 5Ú8"		40
Hex Bolts 5Ú16"-18 x 1		4
Hex Nuts 5Ú16"-18		44
Flat Washers 5Ú16"		48
Lock Washers 5Ú16"		44
Tools Needed:
12mm Wrench or Socket		1

NOTICE

Do not final tighten the stand bolts until all the stand components have been assembled and the saw is rightside-up.

To assemble the stand:

1.With the help of an assistant, place the saw face-down on the floor. NoteÑLay clean and staple-free cardboard down to protect the table surface.

2.Place the short ÒLÓ side supports on the bot- tom of the saw body (Figure 12). NoteÑ Make sure the cast logo is facing the front of the machine.

Cast Logo

Figure 12. L side support installation. G0444/G0444Z 10" Table Saw