6.Tighten the hex nut on the motor bracket to secure the motor bracket shaft into place.
7.Slide the motor assembly onto the two shafts protruding from the back of the saw (Figure 21).
Setscrews
Shafts
Figure 21. Installed motor assembly.
8.Using a 4mm Allen wrench, tighten the two setscrews (Figure 21) in the motor bracket to secure the motor assembly to the shafts.
9.Raise the motor assembly and slip the V-belt over the motor and arbor pulleys (Figure 22). Lower the motor assembly to tension the V- belt.
!
Figure 22. V-belt installation.
10.Place a straightedge across the arbor pulley and the motor pulley. The straightedge should align across the face of both pulleys (Figure 23).
!
Figure 23. V-belt alignment.
ÑIf the pulleys are not aligned, loosen the bolts tightened in step 4 and reposition the motor.
11.Secure the V-belt guard to the V-belt plate with the brass wing nut (Figure 24).
Figure 24. Installed pulley cover.
G0444/G0444Z 10" Table Saw |