Motor
Components and Hardware Needed: | Qty |
Motor | 1 |
Motor Plate | 1 |
Motor Bracket | 1 |
Motor Bracket Shaft | 1 |
1 | |
1 | |
Hex Bolts | 4 |
Hex Nuts | 4 |
Flat Washers 5Ú16" | 8 |
Lock Washers 5Ú16" | 4 |
Carriage Bolt | 1 |
Brass Wing Nut | 1 |
Speed Nut 1Ú4" | 1 |
Tools Needed: |
|
12mm Wrench or Socket | 1 |
10mm Wrench or Socket | 1 |
4mm Allen Wrench | 1 |
To install the motor: |
|
1.Using a 12mm wrench, loosely secure the motor to the motor plate with the hex bolts, the lock washers, the flat washers, and the hex nuts (Figure 18).
Motor Plate
Figure 18. Installed motor plate.
2.Slide the carriage bolt through the hole in the V-belt plate and slide the speed nut over the carriage bolt end.
3.Slide the v-belt plate between the motor and the motor plate and over the hex bolts (Figure 19).
V-Belt Plate
Figure 19. Installed V-belt plate.
4.Finger tighten the fasteners that secure the motor to the motor plate.
5.Secure the motor plate to the motor bracket with the motor bracket shaft (Figure 20). NoteÑThe hex bolt on the motor bracket must align with the groove on the motor bracket shaft.
Motor Bracket Shaft
Motor Bracket
Figure 20. Installed motor bracket.
G0444/G0444Z 10" Table Saw |