Start Up
Loose hair and clothing could get caught in machinery causing seri- ous personal injury. Keep loose clothing rolled up and long hair tied up and away from machinery.
Projectiles thrown from the machine could cause serious eye injury. Wear safety glasses during assembly.
Before starting the machine:
1.Read the entire instruction manual.
2.Make sure the blade guard and splitter are installed and correctly adjusted.
3.Make sure all tools and objects have been removed from the machine.
4.Review Section 3: Circuit Requirements.
5.Keep a finger on the STOP button at all times during the test run.
Starting the machine:
The Model G0444/G0444Z is operated by a push button switch that is clearly labeled
START/STOP.
This switch can be locked out by sliding a pad- lock through the START button (Figure 38b) when the machine is not in use.
Figure 38b. Locked power switch
Recommended
Adjustments
The adjustments listed below have been per- formed at the factory and no further setup is required to operate the machine.
However, because of the many variables involved with shipping, we recommend at least check the following adjustments to ensure the best possible results from the new machine.
All of these adjustments are covered in
Recommended adjustment checklist:
¥Blade Parallelism (page 41)
¥45û Blade Stop (page 44)
¥90û Blade Stop (page 44)
G0444/G0444Z 10" Table Saw |