BladeFence
Components and Hardware Needed: | Qty |
Blade (Not Included) | 1 |
Arbor Nut (Left Hand Threads) | 1 |
Arbor Flange | 1 |
Tools Needed: |
|
23mm Wrench | 1 |
To install the blade guard:
1.Using a 23mm wrench, loosen the arbor nut. NoteÑThe arbor nut has left hand threads.
2.Remove the arbor nut and the arbor flange.
3.Slide the blade over the arbor. NoteÑMake sure the teeth are pointing in the correct direction (Figure 27).
! |
Teeth Direction |
& Blade Rotation |
Front Of Saw |
Figure 27. Correct blade direction.
4.Re-install the arbor flange and the arbor nut and tighten them against the blade.
Install the Shop Fox® fence and rails according to the fence manual.
Switch
Components and Hardware Needed: | Qty |
Switch | 1 |
Tools Needed: |
|
10mm Wrench or Socket | 1 |
To install the switch: |
|
1.Remove the far left hex bolt that secure the front fence rail to the fence bracket.
2.Using a 10mm wrench, secure the switch to the fence rail with the hex bolt (Figure 28) removed in step 1.
Hex Bolt
Figure 28. Installed switch.
G0444/G0444Z 10" Table Saw |