Woodstock W1824 manual Dust Collection, To connect a dust hose to the table saw, do these Steps

Df[\cN(/)+('?pYi`[KXYc\JXn

J<KLG

22.Attach the switch to the bottom left-hand side of the front rail using (2) M5-.8 x 12 cap screws, (2) 5mm lock washers, and (2) 5mm flat washers (see Figure 23).

Dust Collection

Recommended CFM at Dust Port: 400 CFM

Do not confuse this CFM recommendation with the rating of the dust collector. To determine the CFM at the dust port, you must take into account many variables, including the CFM rating of the dust collector, the length of hose between the dust collector and the machine, the amount of branches or Y's, and the amount of other open lines throughout the system. Due to the numerous variables involved, we do not cover this calculation in this manual. If you are unsure of your system, consult an expert or purchase a good dust collection "how-to" book.

DO NOT operate this machine without an adequate dust collection system. This machine creates substantial amounts of wood dust while operating. Failure to use a dust collection system can result in short and long-term respiratory illness.

Tools Needed	Qty
Dust Collection System	1
Dust Hose 4"	1
Hose Clamps 4"	2
To connect a dust hose to the table saw, do these
steps:

1.Fit a 4" dust hose over the dust port, as shown in Figure 24, and secure it tightly in place with a hose clamp.

2.Tug the hose to make sure it does not come off.

Note: A tight fit is necessary for proper performance.

Tip: To make the job of attaching the dust hose easier, we recommend using the Model W1038 Quick Disconnect (see Figure 25). This will be especially helpful if the table saw is mounted on a mobile base.

-20-

x2

Figure 23. Switch installed.

Figure 24. Dust hose secured to the table

saw.

Figure 25. Model W1038 Quick Disconnect.