Woodstock W1824 manual Locations of the front trunnion Shims Blade tilted to

Df[\cN(/)+('?pYi`[KXYc\JXn

11.Tilt the blade to 45° and recheck the miter slot-to- blade parallelism.

—If the blade is still parallel with the miter slot, no additional adjustments need to be made. Skip ahead to Step 15.

—If the blade was parallel with the miter slot at 90° but not at 45°, continue to Step 12.

12.Depending on the result of Step 11, loosen the front or rear trunnion cap screws 11⁄2 turns and remove one shim from each side of that trunnion.

—If the distance of A is greater than B, remove one shim from each side of the front trunnion (locations #1 and #2 in Figure 98).

—If the distance of B is greater than A, remove one shim from each side of the rear trunnion (locations #3 and #4 on Figure 99).

13.Re-tighten the cap screws and re-check the blade-to- miter slot parallelism at 90° and 45°.

—If the distance of A and B are equal, no further adjustments need to be made.

—If the distances of A and B are not equal, repeat this entire procedure until they are.

14.Once the miter slot is adjusted parallel to the blade, make sure that mounting fasteners are secure.

15.Re-install the rear trunnion access panel and close the motor access cover.

		Blade tilted to 45°
Front	#1
			A	B
Trunnion	#2

Figure 98. Locations of the front trunnion

shims.

Blade tilted to 45°
		#3	Rear
A	B
			Trunnion
		#4

Figure 99. Locations of the rear trunnion

shims.

J<IM@:<

-62-