Graco 238512, 238515, 238511 Error Code Cause Solution, Shut-off Default Amount section

Troubleshooting

Error Codes

Error codes are listed below. Even in an error condi- tion, the unit keeps track of the amount dispensed. With any error code displayed, as shown at right, you can

DPress the Manual/Reset button.

Error code is cleared, unit switches into Manual mode, and dispensed amount is displayed.

DPress the Auto/Reset button.

Error code is cleared, unit switches into Auto mode, and the preset amount is displayed.

! CAUTION

To prevent overfills and spills

D Do not obstruct the trigger D Do not operate below 32_ F (0_ C) D Do not leave unattended D Read instruction manual

Maximum Working Pressure 7 MPa (70 bar, 1000 PSI)

06044A

Error Code	Cause	Solution
Err 1	Flow rate is higher than 5 gpm.	Adjust the flow rate so it is not higher
	or	than 5 gpm.
	Air was pumped through the line.	Purge air from the line.
Err 2	Switch Error: Error occurred with	Ensure that your flow rate is not
	pick-up in internal gear.	higher than 5 gpm. For further assis-
	or	tance, contact your Graco distributor.
	Unit was dropped or unit encoun-	Press the Manual/Reset button at
	tered excessive vibration during	start-up.
	shipping.
Err 4	Flow has continued after it should	Check if the unit is resting on the
	have shut off.	trigger or if an obstruction is pressing
		the trigger. The unit checks for flow
		every two seconds, and it beeps and
		repeats the error code until the
		trigger is released and the error code
		cleared.
Err 5	The unit has dispensed the shut-off	Press the Manual/Reset button, and
	default amount and has stopped	dispense again. To change the
	fluid flow.	shut-off default amount, see the
		Shut-off Default Amount section
		on page 10.
Err 6	A preset dispense amount of zero	Enter an amount that is not zero.
	was entered for the dispense or is	See the Auto Preset Amount
	stored as the default, and a Preset	section on page 9.
	dispense was attempted.

309377 15