Graco 238515 Shut-Off Default Amount, This menu, you can change the shut-off default amount

Page 10

Setup

Shut-Off Default Amount

The shut-off default amount is for preventing acciden- tal overfills when dispensing with the trigger locked in Manual mode. The shut-off default amount is factory preset at 5 quarts.

In this menu, you can change the shut-off default amount.

1.If you have not already entered the dispensing options menus, do steps 1 and 2 in Selecting Dispensing Options on page 8.

2.Press the Auto/Reset button repeatedly until the clock icon blinks, and the stored shut-off default amount is displayed to indicate that you are in the Shut-off Default Amount menu.

3.With the clock icon blinking and the stored shut-off default amount displayed, as shown below, do ONE of the following two options:

D Enter a new shut-off default amount by press- ing the 10 button to change the 10s digit, the 1.0 button to change the 1s digit, and the 0.1 button the change the first decimal digit. You cannot enter zero. To lock in the new shut-off default amount and exit the dispensing options menus, press the Auto/Re- set button.

The PM5 beeps and returns to the Manual dispense mode to indicate that you have exited the dispensing options menus.

OR

DPress the Auto/Reset button.

The PM5 beeps and returns to the Manual dispense mode to indicate that you have exited the dispensing options menus.

QTS

! CAUTION

To prevent overfills and spills

D Do not obstruct the trigger D Do not operate below 32_ F (0_ C) D Do not leave unattended D Read instruction manual

Maximum Working Pressure 7 MPa (70 bar, 1000 PSI)

06044A

10 309377

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Important Safety instructions Instructions -- Parts ListModel 238511 shown Table of Contents SymbolsFire and Explosion Hazard Mounting Bracket InstallationTypical Installations Mounting bracketPre-Installation Procedure Pressure Relief ProcedureInstallation Procedure Steps 2 through 6 are the Flushing ProcedureGrounding 309377 Model shown has Bend rigid ExtensionTerms SetupManual / Reset and Auto / Reset Keypad ButtonsSelecting Dispensing Options Resettable TotalUnits of Measurement Calibration Number Auto Preset AmountCalibration Factor Fluid Quarts LitersShut-Off Default Amount This menu, you can change the shut-off default amountLocking and Unlocking the Trigger Dispensing Fluid in Manual ModeOperation Checking Segments in the DisplayDispensing Fluid in Auto Mode Viewing TotalsBattery on TroubleshootingProblem Cause Solution Replacing the Filter onRings. See Servicing the Valve Installation ProcedureSee in Installation Proce Automatic Nozzle onSee the Auto Preset Amount Error Code Cause SolutionShut-off Default Amount section ErrReplacing the Battery ServiceReplacing the Filter Servicing the Valve Replacing the Automatic NozzleDescription Qty Parts ListIncludes 16a to 16e, 25, Meter housing Parts DrawingTechnical Data Dimensional Drawing Graco Information Graco Standard WarrantyToll Free 612--623--6928 612--378--3590 Fax
Top Page Image Contents