If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
•Fixture must be connected to a 120 Volt, 60 Hz power source. Any other connection voids warranty.
•Total wattage of light bulbs connected to the motion detector cannot exceed 300 watts incandescent.
•This motion detector should be installed by persons with experience in household wiring or by a qualified electrician. The electrical system, and the method of electrically connect- ing the fixture to it, must be in accordance with the National Electrical Code and local building codes.
•For proper operation and protection against damage, the motion sensor head adjustment knobs must be facing the ground.
•Disassembly of your detector will void the warranty.
SAVE THESE INSTRUCTIONS.
For best results
• Install your fixture
• Locate fixture so motion moves across detection zone (D).
• Locate fixture away from heat producing sources to prevent false
triggering. Also be very careful not to include objects such as |
| ||
windows, white walls and water in the detection zone whenever |
| ||
possible. | D | ||
• Locate fixture away from moving objects such as trees and | |||
| |||
street traffic. |
| ||
• Do not install more than one motion detector on one wall switch. |
| ||
|
|
| |
Assembling and wiring your motion detector |
| ||
Step 1: Turn off the power at the main | fuse/breaker box. |
| |
Step 2: Screw motion detector arm into the desired hole on |
| ||
junction box coverplate. |
| ||
Step 3: Attach all lampholders or light fixtures to the coverplate |
| ||
as required by light fixture instructions . |
| ||
Step 4: Connect the wires together. Connect all white wires |
| ||
together (house wire, detector wire, and lamp fixture |
| ||
white wires) using wire nuts provided. Connect black | E | ||
lamp wires to red wire from the detector. Connect | |||
black house wire to black wire from the detector (E). |
| ||
Step 5: Attach fixture to the junction box according to light fixture instructions.
Step 6: Apply silicone caulking around the edges of coverplate and in any open screw holes for a watertight seal.
Step 7: Insert bulb(s) according to light fixture instructions.
Your fixture mounts
to the following standard
junction boxes:
Step 8: Turn power on at main fuse/breaker box. Round | Rectangular (horizontal) Octagonal |
How to operate your fixture
Step 1: Move slide switch on bottom of the sensor to “TEST”. Set sensitivity slide switch to medium or “M”(halfway) (F).
3