Powering the SF601
1.Open the battery door pulling the battery door latch.
The SF601will be shipped with alkaline batteries.
Rechargeable batteries can be used optional but need to be charged externally
2.Insert four AA batteries noting the plus (+) and minus
3.Close the battery door. Push down until it “clicks” into the locked position.
SF601 - Features and Functions
1. Power/Mode Button: Press and release the power button to turn ON the SF601. All display LED’s will light for 1.0 sec.
Press and hold power button for >1 sec. to turn OFF the SF601. After 1 sec. all display LED’s will light 1.0 sec.
Note: Wurde der SF601 eingeschaltet, wird durch kurzes Drücken der
LED’s:
2. LED1:
solid green when SF601 is on and battery OK blinking red if battery voltage is 3,8V<V bat <4V solid red if battery voltage is <3,8V;
4
SF601 turns off automatically after 5 min.
3. Mode LED2:
yellow solid: automatic mode
flashing: none or lost signal
off: manual mode | 3 | 1 | |
4. Direction LEDs red: | 2 | ||
|
Manual mode: pointing towards the center of the plumb beam.
All 4 LEDs are solid red when the beam is centered.
Automatic Spot Lock mode: solid for 5 min., then LED’s flash every 5 seconds.
Using the SpotFinder SF601 for vertical UL applications
With the UL633 using IR connection, the SF601 can be used in three different automatic modes Automatic- Spot Alignment, SpotLok and
21