Epson manual Items Included, Hardware Included with the DW7464 52 Rail System, Tools Included

Items Included

Box #1

Hardware Included with the DW7464 52" Rail System

•(1) 52" rail system table sub-assembly

•(1) Support pan

•(1) Support bracket

•(2) Lower support rail

•(3) Rear brackets

Box #2 (Rail Carton)

•(1) Front rail sub-assembly

•(1) Rear rail

•(2) Legs

•(2) Feet

•(1) Hardware bag

Tools Included

•6mm hex wrench

•Torx T40 wrench

•Torx T50 wrench

Tools Needed

•17 mm open end wrench

•(2) 16mm or 5/8" open end wrench

•13mm or 1/2" open end wrench

•Ruler

•Soft hammer or regular hammer and block of wood

•Small flat blade screwdriver

To speed assembly, the following would be helpful:

•16mm or 5/8" socket wrench

•13mm or 1/2" socket wrench

•T25 Torx driver

BOLT

10 mm x 35 mm

(8 PIECES)

BOLT

10 mm x 25 mm

(5 PIECES)

CARRIAGE BOLT

8 mm x 20 mm

T50 TORX

FLAT HEAD SCREW

10mm X 30mm

(6 PIECES)

M 10 NUT 16 mm HEX

(13 PIECES)

M 8 NUT 13 mm HEX

(25 PIECES)

8 MM LOCK WASHER

(25 PIECES)

English

6 MM HEX SOCKET FLAT HEAD SCREW 10mm X 80mm

(2 PIECES)

Necessary Hardware

The included hardware bags contains all the necessary nuts, bolts, and washers to assemble the components included with the DW7464 52" Rail System and to attach it to the DW746 Woodworker’s Table Saw. (When attaching as an add-on accessory use new hardware in place of removed hardware).

To make assembly of your saw/accessory easier, match the nuts, bolts, and washers with the hardware chart. Before each step, check your hardware against the chart and identify the pieces you need. Additional pieces may be included in the hardware bags.

(11 PIECES)

8MM FLAT WASHER (19 PIECES)

10MM FLAT WASHER
(22 PIECES)	M 10 JAM NUT 17 mm HEX
	(6 PIECES)
	CAP HEAD SCREW
10 MM LOCK WASHER	8mm x 20 mm
	(15 PIECES)
(20 PIECES)

1