Air Vent Inc IM10065 manual TAbLE of Contents

viii	TAbLE OF CONTENTS		viii
			Page
	Installation	Section A
	Technical Specifications		A-1
	Safety Precautions		A-2
	Location and Ventilation		A-2
	Storing		A-2
	Stacking		A-2
	Angle of Operation		A-2
	Lifting		A-3
	High Altitude Operation		A-3
	High Temperature Operation		A-3
	Towing		A-3
	Vehicle Mounting		A-3
	Pre-Operation Engine and Compressor Service		A-4
	Oil		A-4
	Fuel and Fuel Cap		A-4
	Engine Coolant System		A-4
	Battery Connections		A-4
	Muffler Outlet Pipe		A-5
	Spark Arrestor		A-5
	Air Cleaner Inlet Hood		A-5
	Welding Terminals		A-5
	Welding Output Cables		A-5
	Machine Grounding		A-5
	Remote Control		A-6
	Auxiliary Power Receptacles and Standby Power Connections		A-6, A-7
	Connection of Lincoln Electric Wire Feeders		A-8, A-9
	________________________________________________________________________________
	Operation	Section b
	Safety Precautions		B-1
	General Description		B-1
	Recommended Application - Welder, Air Compressor and Generator		B-1
	Controls and Settings		B-2
	Engine Controls	B-2, B-3
	Welder Controls	B-3, B-4
	Auxiliary Power Controls		B-4
	Air Compressor Controls		B-5
	Battery Jump Start Terminals		B-5
	Engine Operation		B-6
	Engine the Engine		B-6
	Cold Weather Starting		B-6
	Stopping the Engine		B-6
	Break-In Period		B-6
	Typical Fuel Consumption		B-6
	Welding Operation		B-7
	Duty Cycle		B-7
	Stick Welding Mode		B-7
	CC-Stick Mode		B-7
	Downhill Pipe Mode		B-7
	Touch Start TIG Mode		B-7
	AIR VANTAGE® Settings when using K930-2 TIG Module		B-7
	Wire Welding-CV		B-8
	Arc Gouging		B-8
	Typical Current Ranges for Tungsten Electrodes		B-8
	Paralleling		B-9
	Auxiliary Power Operation		B-9
	Simultaneous Welding and Auxiliary Power Loads		B-9
	Simultaneous Welding and Power Loads, Extension Cord Length Recommendations		.......B-9